<1>
Port mode:
serial port:
Baud rate:
Check digit:
Data bits:
Stop bits:
Use number:
Remote address:
Remote Port:
Local Port:
COM
UDP
TCP S
TCP C
OK
cancel
<2>
Description(Double-click settable)
Turn on Mouse Mobility 
Turn on TUIO
Open the function of continuous mouse click
Turn on the mouse click-and-drag function
Open Mouse Intelligent Detection Mode
Turn on the mouse Location function
Turn off the simulated mouse function
Play the last material
Play the next material
Turn off the playback function
Save Settings
[Mouse Roller]: Radar Picture Scaling
[Right-click the mouse]: Pop-up menu
[Drag right mouse button] or [Del + Click Object]: Eraser
[Ctrl + drag right mouse button]: erase the eraser
[Ctrl + Moving Effective Area Calibration Point]: Points Linkage
[Ctrl + Moving Screen Position Calibration Point]: points are not linked
[Shift + Moving Screen Position]: Effective Area points are not linked
<3>
Save set
Start set
Instruction
Add invalid
Del Invalid
Add Radar
Set Radar
Set
Radar settings
Adding Subradar
Radar set up
Delete radar
Radar Data Access
Read Radar Data
Save Radar Data
Camera settings
Adding Camera
Modification of camera parameters
Delete the camera
Adding valid zones
Split valid zones
Revoke split
Delete valid area
Adding invalid zones
Delete invalid area
Reset all Settings
Sending TUIO Protocol
don't click
Continuous click
drag the mouse
Intelligent Mode
Location change Click
move
continuity
drop
Intelligence
Location 
None
X axis
Y axis
Both
The mouse range is a ratio of 0 to 1. If it is less than 0 or larger.
When the object exceeds this millimeter, the mouse as a right-click, always as fill-in 0, never as fill-in -1.
After modifying radar parameters, it is necessary to save the settings and restart the program to run normally. Do you want to continue setting?
After deleting the radar, you need to save the settings and restart the program to run normally. Do you want to continue deleting?
Display basic settings 
Display all setting 
Angle:
Salce:
rotation:
Save Success
Save Fail
Caution!Zone deformation serious!
Input Horizontal Split Count
Reset Settings,Are you Sure?
Left upper
Right upper
Left lower
Right lower
object area
Distance between 
Mouse Right area
        NONE
           UDP
            TCP
WM_Touch
  address
Mouse mode
Mirror mode
Hide Mouse
Radar speed
Color display
Radar frequency
Open Mouse Event
TUIO (Basic)
TUIO (Detailed)
Calibration
Auto Angle
Disturbances are being removed. Please wait...
Touch the red area in the upper left and don't leave.
Touch the green area in the upper right and Don't leave.
Touch the blue area in the lower left and Don't leave.
Touch the yellow area on the lower right and do not leave.
Calibration failed, long time no touch specified area
Calibration failed and multiple touch areas were detected
Calibration success
<4>
Start-up Settings
Select Program 
Select Path
Add 
Add Path
Delete
Test Run
Delay/Black (SEC)
Running time
Window mode
Starting mode
Touch Mode
Random
Loop
Number Run
StartUp Run
Real Run
Save
hide
normal
minimize
Maximization
Simultaneous operation
Sequential operation
Use Saved Setting
delayed 
black   
 sec
Continuous operation
Function
hide
normal
minimize
Maximization
Normal Focusless
Minimizing Focusless
Simultaneous operation
Sequential operation
<5>
Adjust the interface is locked, please turn off the "Open Mouse Event" function first.
Input Vertical Split Count
Split valid zones(Round)